As Dye Free Soy pillar candles

3 x 3 Round Pillar Soy Candle-DYE FREE

Materials needed:

EcoSoya Pillar Blend
Thermometer
3 x3 round aluminum
Mold Release
Wick Eco 12
Wick bar clips or clothes line
1 to 1.5 oz fragrance oil
Polyurethane plastic spoon
Timer

There are many different shapes and sizes pillar shapes. The molds are silicon steel, aluminum, plastic and polyurethane. forms are made of aluminum and ironvery durable and will last many years.

Step 1: Start digging EcoSoya pillar blend wax melting in the pitcher. Allow wax to 185 degrees (Fahrenheit to melt). While the wax is melting layout old newspaper to catch any spills and then fix the column (s) used.

Step 2: Thread your wick wick Eco hole 12 of the mold. The wick hole on the underside of the instrument. Note: Make sure that the forms of column are pre-drilling before buying. If youfind it difficult to thread the wick through the hole Wick, simply soak in a casting wax and wick roll with fingers pointed at one end. Secure the end with a wick screw and unscrew then use the gray or white glue and place the wick up. Make sure the screw wick is safe but not particularly close, because this causes damage to the wick or mold. This area will be at the top of the candle over.

Step 3: While the wick as straight as possible to guarantee with a wick pin, tiea wooden stick.

Step 4: Once the wax is completely melted, add fragrance oil and mix well. I recommend your first fragrance oil so you can see that each well mixed in the wax.

Step 5: Allow wax to around 140-145 degrees (Fahrenheit) cooler. While your wax cools, this column would be a good time to spray a thin layer of release agent in the form (s) be. A silicone or Pam spray is suitable. This helps to release aid of the final columnCandle. Mold Release Spray is highly recommended for new forms.

Step 6: By now the pillar wax melting right (140-145 degrees) to fill the form column (s) ½ inch from top of mold. Save to do a little 'wax, one to pay again. Do not come into heat melting pot.

Step 7: Keep your wax cold. After the wax solidifies, but still very warm poke drain holes in the base of the candle is to accommodate shrinkage. Place the relief holes around the wick and shouldbe about an inch deep. Several drain holes may be necessary during this process. Do you let the candle cool completely, which could take several hours for large columns, which could take 24 hours.

Step 8: Take your left from the point of soy wax and 6 re-melt. Make sure the temperature is 5-10 degrees warmer than before. The reply should be collected, because adherence to warm between layers AIDS. Once the wax is at the proper temperature, fill the potholes of your candle. Again, noDo not fill the top of the form. Simply fill just above the first level in order to avoid horizontal lines of stitching.

Step 9: Allow to cool completely your pillar candle. Now remove the mastic (sealant mold) and the wick screw. Your candle should slide right mold. If you have problems with IT experience right out of the house, in the freezer for 5 minutes or in refrigerator for 15 minutes. This will cause the wax to shrink and separate from the mold.
Wick wick attached to the bar orWooden sticks, the bottom of the candle. Cut the wick at the end with sharp scissors. The wick should be cut flush with the base of the candle.